News Center

NEWS CENTER

How to replace the car tie rod ball joint assembly?


Release time:

2023-08-15

How to change the car tie rod ball head is simple, directly disassemble and replace, and then adjust the toe, just shake the tire left and right by hand to see if the tie rod ball head is loose!

1. How to change the car tie rod ball end is simple, directly disassemble and replace, and then adjust the toe, just shake the tire left and right by hand to see if the tie rod ball end is loose!

2. How to check and adjust the tightness of the longitudinal tie rod ball pin The easy way to check the tightness of the longitudinal tie rod ball pin is: one person shakes the steering wheel back and forth in the cab, and one person observes whether the longitudinal and transverse tie rod ball heads are loose under the car. Adjust the tightness of ball stud as follows:

1) Take out the cotter pin used for locking and adjusting the screw plug, screw the screw plug to the end with a special tool, make the spring seat press the ball head bowl, and then return the screw plug by 1/4~1/2 turn until the cotter pin can be inserted.

2) At this time, the ball joint should rotate freely with a little resistance, but not too tight, and there is no clamping phenomenon.

3) Reassemble the cotter pin and lock it firmly.

3. Replace the Lifan 520 steering gear assembly with tie rod ball head by yourself. What adjustments should be paid attention to and where to say hello? This is too difficult. It is recommended to go to a professional repair shop to replace it. The steering wheel should be locked and the position should be adjusted when the new one is installed. After installation, four rounds of positioning will be required. Hello, after the vehicle replaces the steering gear assembly, you need to re-adjust the toe value of the front wheels of the vehicle. Hello, when you replace the steering gear yourself, pay attention to first pull out the key, lock the steering wheel, and remove the steering gear and the steering wheel. Then remove the tie rod ball head and watch the position. Generally, if the position is not clear, you need to do four-wheel alignment after the replacement. It is not easy to remove the anaerobic glue. It is more troublesome to replace the steering gear assembly. You must have a lift before you can replace it. You cannot replace it at all, because this operation is more convenient. It is recommended to go to the repairman of the repair shop to help you replace it. After the replacement, you need to do a four-wheel alignment.

4. How do you adjust the Poussin direction tie rod? There are two screw caps at the ball end of the tie rod. You can send the screw caps away, one for the main wire and one for the reverse wire. Just release it and adjust it.